Remove

PO4x4 Phosphate Remover

PO4x4 Phosphate Remover
PO4x4 Phosphate Remover

Chemical engineered polymer Phophate Remover

  • hardly leaking of Iron-ions
  • pellets do not clump
  • very high surface area
  • Manufacturer:DvH
  • Item number:V16610
starting from 21,50 €

including 19% VAT. ,

Recommended retail price: 21,50 €

Maintaining the levels of waste products low while feeding your animals on a regular basis is essential for keeping invertebrates and fish in good health. In microbial well balanced aquaria, the two major pollutants are nitrates and phosphates. With current use of NP-Reducing BioPellets, it has become very easy to maintain nitrates and phosphate levels close to zero, however, in most tanks there is still a surplus of phosphates. Phosphate levels exceeding 0.03 ppm will negatively affect coral growth and higher levels will also negatively influence the health of your fish. In addition, high phosphate levels enhance the growth of annoying algae and cyanobacteria. Most of current phosphate reducing products are based on granular ferric hydroxide and leak iron-ions into your tank, which is enhancing algae growth and inhibiting coral growth and have a tendency to start clumping together, thus reducing its effectiveness.

Almost every other iron based GFO is releasing iron-ions to the water up to 10 times more than natural seawater levels. This is tested and confirmed at the university of Wageningen, Holland. The tests were done with a inductively coupled plasma mass spectrometer.

Our novel PO4X4 Phosphate Remover is a unique chemical engineered polymer based mini pellets that does not have these down sides. In other words, there is hardly any leaking of Iron-ions, the pellets do not clump together and can be readily used in fluidized filters. They have a very high surface area and can absorb approximately 4 times more phosphate then most other phosphate removing products. 250 ml will remove 3 ppm of phosphate and silicate from roughly 8.000 liter of fresh water or 4.000 liter of marine water.

Do not overdose! Rapid changes in phosphate can negatively affect your animals. Use small amounts of PO4X4 to gradually lower the phosphate levels in your aquarium.

250 ml will remove 3 ppm of phosphate and silicate from roughly 8.000 liter of fresh water or 4.000 liter of marine water. Do not overdose! Rapid changes in phosphate can negatively affect your animals. Use small amounts of PO4X4 to gradually lower the phosphate levels in your aquarium.